[SML] Push-In fittings

[Joe]

My own experience with 3D printers is that they cannot be used for air.  The inter-layer bonding is prone to having small air gaps.  Bonding between layers is also not that great.  I can easily seeing even fairly moderate air pressure, blowing a 3D print up.
Another source for press-on fittings is Coast Pneumatics.www.coastpneumatics.com I found some relatively low cost versions there once. There on-line catalog leaves a lot to be desired, but they carry a lot more than what you see on line, if you call them.

Also, note that other words are sometimes used to describe the "Press-on" fittings that is the more generic term.  Speedfit is one.  Coast Pneumatics calls their general category "Push quick fittings"

-Joe
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://theatrical.net/pipermail/stagecraft_theatrical.net/attachments/20170907/4aada5fe/attachment.html>