<div dir="ltr">Hi Andrew<div><br></div><div>When we last did our floor about 9 years ago, the origional floor bubbled and buckled a bunch and required lots of additional nails and screws to keep flat, it was just poorly installed</div><div><br></div><div>We had the flooring delivered about 4 months early, let it sit for 2 months then spent a month painting both sides and edges with Rosco tough prime<br><br>To lift the old deck, we used a roofing scraper and pry bars, trying to remove any nails or screws before lifting the sheets of maso was a waste of time as 90% of the nails came up when we peeled the sheets<br><br>after the deck was removed, use the backside of a push broom, the wooden head will snag on anything that shouldnt be there, you then make a decision on if it will be better to pound it down or pull it out, some of the broken screws met the flap disk grinder<br><br>before laying the sheets, do chalk lines for important lines and every couple of rows, we did a centre line and a drape line (if you want it behind the main drape, it needs to be behind this line) - I would probably do 1/4 marks for dancers next time - its worth the extra maso<br><br>we installed the sheets with a nickles as spacers and used a nail gun to place the sheets, the chalk lines ensure you are not drifting, and lets you adjust before committing, we then put a ring nail approx every square foot. <br><br>The next step was 2 additional top coats of tough prime with a week of dry time between coats (we are lucky to be dark in august) with special attention to getting paint into the cracks (to try to seal against glitter), pouring and spreading vs paint trays puts a much thicker coat down<br><br>The biggest issue we have is that the maso that was purchased is not double tempered and does pull up, the paint seems to be stronger than the maso<br><br><br>George Davidson</div><div>Clarke Theatre</div><div>Mission BC</div></div>