[SML] Problem with I-Que on Element Desk

[Fritz, Barry]

Thanks.  Turning off RDM seems to have solved it.  They ran for several months without issues.  Strange that only a few of the I-cues were affected.

Barry

> On Jun 19, 2017, at 12:06 AM, Chad Croteau via Stagecraft <stagecraft at theatrical.net> wrote:
> 
> It won't hurt anything to slow down the DMX refresh rate on the console.
> The other area I've had cause unintended problems is with having RDM enabled
> on lines where non-RDM devices were connected.  Try going into the setup and
> slowing down the DMX transmission value as well as de-activating RDM.
> 
> Cheers!
> 
> Chad
> 
> -----Original Message-----
> From: Stagecraft [mailto:stagecraft-bounces at theatrical.net] On Behalf Of
> Fritz, Barry via Stagecraft
> Sent: June-18-17 2:06 AM
> To: Stagecraft Mailing List <stagecraft at theatrical.net>
> Cc: Fritz, Barry <fritzbl at etown.edu>
> Subject: Re: [SML] Problem with I-Que on Element Desk
> 
> Just recently started having issue with one of seven using a Martin M1.
> Figured it was a problem with the unit,  pulled it apart and did not find
> anything obvious except a lose connection.  The lose connection may have
> occurred while taking it apart.
> 
> Worked fine when I put it back into service but then started failing again a
> few days later along with the unit just before it in the chain.
> 
> After reading your post I'm wondering if it may be a DMX refresh rate issue.
> 
> Thoughts?
> 
> Barry
> 
>> On Jun 18, 2017, at 1:54 AM, Bill Nelson via Stagecraft
> <stagecraft at theatrical.net> wrote:
>> 
>> I am using a couple of Rosco I-Que scanning mirrors in the show I am 
>> currently designing and have run across a problem.
>> 
>> When I set the I-Ques to 8 bit mode and patch the 8B configuration 
>> into the Element desk, the moving light controls work perfectly. But 
>> when I set them to
>> 16 bit mode and patch the Element with the 16B configuration, the pan 
>> works correctly but the tilt jumps all over the place.
>> 
>> Has anyone else encountered this problem with the I-Que?
>> 
>> Bill
>> 
>> 
>> 
>> 
>> 
>> ____________________________________________________________
>> For list information see <http://stagecraft.theprices.net/>
>> Stagecraft mailing list
>> Stagecraft at theatrical.net
>> http://theatrical.net/mailman/listinfo/stagecraft_theatrical.net
> 
> ____________________________________________________________
> For list information see <http://stagecraft.theprices.net/>
> Stagecraft mailing list
> Stagecraft at theatrical.net
> http://theatrical.net/mailman/listinfo/stagecraft_theatrical.net
> 
> 
> ____________________________________________________________
> For list information see <http://stagecraft.theprices.net/>
> Stagecraft mailing list
> Stagecraft at theatrical.net
> http://theatrical.net/mailman/listinfo/stagecraft_theatrical.net