[SML] Help! big 3D printer mess

[John Taylor]

And here also.
I thought the attachment rule got changed a couple of years back. But my
old brain is not sharp always.

JT

On 5/4/2020 10:30 AM, John T. Cotton via Stagecraft wrote:
> FWIW, The photo made it through here.
>
> On Mon, 4 May 2020 07:55:01 -0700, Michael Millar via Stagecraft wrote:
>>   You'll probably need to disassemble the hot end entirely. An
>>   acetone bath might loosen things up. What model printer? On my old
>>   Replicator 2, I had to just flat out replace the hot end after an
>>   all-night print lifted from the print bed encasing the head in
>>   plastic. It might be cheaper and easier to just replace it. When I
>>   got my Ender 3, I upgraded the hot end to a Swiss Tek to prevent
>>   the issue you experienced. BTW, your picture got scrubbed in the
>>   email. This list doesn't do attachments. Try on the FB page.
>>
>>   Cheers,
>>   Michael
>>>   ------------------------------------------------------------------
> John T. Cotton
> Event Audio-Stage Lighting-Production Management
> Freelance Engineering & Consulting
> John at frugalaudio.com
> WWW.FRUGALAUDIO.COM
> (716) 213-7485
>
>
>
> ____________________________________________________________
> For list information see <http://stagecraft.theprices.net/>
> Stagecraft mailing list
> Stagecraft at theatrical.net
> http://theatrical.net/mailman/listinfo/stagecraft_theatrical.net

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://theatrical.net/pipermail/stagecraft_theatrical.net/attachments/20200504/f73b2c87/attachment.html>