[SML] Problem with I-Que on Element Desk

[Fritz, Barry]

Just recently started having issue with one of seven using a Martin M1.  Figured it was a problem with the unit,  pulled it apart and did not find anything obvious except a lose connection.  The lose connection may have occurred while taking it apart.

Worked fine when I put it back into service but then started failing again a few days later along with the unit just before it in the chain.

After reading your post I'm wondering if it may be a DMX refresh rate issue.

Thoughts?

Barry

> On Jun 18, 2017, at 1:54 AM, Bill Nelson via Stagecraft <stagecraft at theatrical.net> wrote:
> 
> I am using a couple of Rosco I-Que scanning mirrors in the show I am currently
> designing and have run across a problem.
> 
> When I set the I-Ques to 8 bit mode and patch the 8B configuration into the
> Element desk, the moving light controls work perfectly. But when I set them to
> 16 bit mode and patch the Element with the 16B configuration, the pan works
> correctly but the tilt jumps all over the place.
> 
> Has anyone else encountered this problem with the I-Que?
> 
> Bill
> 
> 
> 
> 
> 
> ____________________________________________________________
> For list information see <http://stagecraft.theprices.net/>
> Stagecraft mailing list
> Stagecraft at theatrical.net
> http://theatrical.net/mailman/listinfo/stagecraft_theatrical.net