[SML] SketchUp?

[Dave Vick]

On 1/16/2018 12:52 PM, Steven Hood via Stagecraft wrote:

> Are any of you all using SketchUp as your main CAD software?


Nope; I used to use it for 3D printing until I found out it was really
good (at least on the Mac side) at adding unresolved polygons &
orphaned vertices randomly into every object I tried drawing up &
printing. This may or may not be a factor in your decision to go with
Sketchup, if you're only using it for 2D/lighting work.

YMMV, as always...

-- 
Dave Vick
IATSE #274, Michigan
ETCP Double-Certified Rigger #427
517-749-3859